![]() ![]() ![]() I do see there is suggestion that to run it under pcie 1.1 mode. One thing for sure is that if leave it running for whole night, no matter 3Dmark or GTA5 will crash at sometime. Sometimes it works perfectly for 3 hours. However, it has annoying instability issue. 30~45fps for GTA5 all high setting on 1080p. After installed win10 the 3Dmark FSE shows ~8000 for graphics card. It is almost out of box and no need any further configuration. When switch back to wifi card, the PCIe port appear again. Look furthermore in Aida64, the pcie port where the eGPU is installed is missed. Start up correctly on both "7s" and "14s", however, system can't detect the card. Blackscreen when start up no mater how to set the switch.ī. Power is supplied by 450w ATX. I found there are some problems when connect to both laptops.ĬPU: i5 3320m (can upgrade to i7 2760 am)Ī. I have a exp gdc beast v8 and GTX1070 as the eGPU. if i use hdmi extender, will the performance of my egpu decrease? is there any tricks other than pin 22 isolation? need to rid out this hotplugging.Ģ. So now i have to hotplug it (but in hdmi cable in my exp gdc).ġ. delay to 14s and i tried to isolate pin 22 with clear tape but still same. (with setup 1.3x no luck)īut, i can't pass to setup 1.3/windows with my egpu turned on. I managed to overcome the mpcie whitelist with biosmod. I will make thread for my hp 430 laptop egpu. I think the green led is broken so thats why i thought it didn't work. but i just change the the tape to red color and take out the paperclip. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |